mzero

Forum Replies Created

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • in reply to: Preferred tuning? #8749

    mzero
    Participant

    I’ve been tuning a semitone higher than normal: D/A. Makes it a little easier for me to learn my way around the fret board.

    in reply to: CV post hardware #6338

    mzero
    Participant

    In my Pulsar Buddy project I just used standard machine screws.

    Metric 18-8 Stainless Steel Extra-Wide Truss Head Phillips Screws, M3 x 0.5mm, 16mm long.

    I got them from McMaster, along with matching zinc-plated steel hex nuts:

    For my board, I just put down a plated through hole just big enough to take the screw – and with copper as wide as the screw head on both sides. No fuss mounting – just tighten with a screwdriver!

Viewing 2 posts - 1 through 2 (of 2 total)
Copyright by SOMA Laboratory (This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.) Privacy & Cookies Policy
Right Menu Icon