Bass channel dead?

- Topic
- Voices
- Posts
- Last Post

Log In Register Lost Password

Viewing 2 posts - 1 through 2 (of 2 total)

Author

Posts
May 9, 2023 at 7:45 am #12818 Reply
six_wax
Participant
Sadly, the bass channel on my Pulsar 23 suddenly is not working as it has been.

I have no patch cables connected.

Attack, release, and tuning seemingly have no effect. (Warp and the filters do effect the sound… but the oscillator seems dead. The output when manually pressing the ADD key is a low rumble… sounds like a very low frequency sawtooth rumble. (Again, Tune has no effect)

Can you advise? (All 3 other channels are working normally)

(I’ve done very little patching on this unit fwiw… was really just finding my way around.)
May 11, 2023 at 7:26 pm #12819 Reply
noiseg33k
Participant
Please check the switch on the bass channel to make sure you don’t have it set to MIDI mode.
Author

Posts

Viewing 2 posts - 1 through 2 (of 2 total)

Copyright by SOMA Laboratory (This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.)