Shaos 3bit s/h output is only 1bit

[peejParticipant]

It appears that my shaos 3bit output is only generating hi/lo signals and not 8 distinct voltages. This is after cold starting the unit, and regenerating the sequence doesn’t seem to change anything. In comparison, the direct 2bit output does actually output separate voltages.

Here’s a video of the problem:

Any thoughts on how to service this problem? I have a voltage meter, soldering iron and can be dangerous 🙂

I’m assuming there’s no dip switch that would cause something like this to happen?

Thanks!

Preston

[ground_grownModerator]

Hi Preston, as an experiment, can you try running something into the DATA pin, like noise or the LFO and see if the issue persists?

[Author]

Posts