SPECS & MANUAL / WARP
| Number of algorithms | 15 |
| Minimum input voltage | 0.35 V peak-to-peak |
| Maximum input voltage | 8.3 V peak-to-peak |
| Input impedance | 50 KOhm |
| Output impedance | 1000 Ohm |
| CV nominal range | 0-5 V |
| CV input impedance | 50 KOhm |
| Sample/bitrate | 48 KHz / 24 bit |
| Frequency range | 10 – 22000 Hz |
| Power voltage | DC 12V* |
| Power input polarity | Center positive |
| Current | 0.25 A |
| Dimensions | 220 х 170 х 70 mm |
| Weight (without power supply and packaging) | 1.5 kg |
* Use only the power supply unit included with the device! If that fails, it can be replaced with a high-quality modern switching-mode power supply unit with DC 12V output voltage, “plus” in the center, and output current of 0.3 A or higher. The power supply unit must have a wide input voltage range of 100 – 240 V AC. Such power supplies have an excellent stabilization of their output voltage, which is necessary for WARP to work. Do not power the device with an unregulated transformer power supply — this may cause damage not covered by the warranty.
