Reply To: CV post hardware

Home Forums Instruments PULSAR-23 CV post hardware Reply To: CV post hardware

#6338

mzero
Participant

In my Pulsar Buddy project I just used standard machine screws.

Metric 18-8 Stainless Steel Extra-Wide Truss Head Phillips Screws, M3 x 0.5mm, 16mm long.

I got them from McMaster, along with matching zinc-plated steel hex nuts:

For my board, I just put down a plated through hole just big enough to take the screw – and with copper as wide as the screw head on both sides. No fuss mounting – just tighten with a screwdriver!

    Copyright by SOMA Laboratory (This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.) Privacy & Cookies Policy
    Right Menu Icon