Reply To: setting up LPR to run with a DAW
TvMcC
Copyright by SOMA Laboratory
privacy_link_footer2
Home / Forums / Instruments / PULSAR-23 / setting up LPR to run with a DAW / Reply To: setting up LPR to run with a DAW
As a few suggestions to keep in mind with regards to logic:
Make sure Project Settings -> Synchronization is set up to your Arturia Controller, Clock, PDC, MTC, and MMC.
And as the team has pointed out (I do not have the modules you mentioned yet, unfortunately, but do have a few modules, and a minibrute2) make sure your daisy chain is set up, and you are following suggested signal flow in the manuals and you should be set!
Oh another area to make sure is set up to receive midi control values is in your preferences -> Midi – Reset Messages. Tick boxes where appropriate to your needs. Hope this helps, best of.
